火灾自动报警系统-Jiangsu jotry Electric Technology Co., Ltd.

火灾自动报警系统

火灾报警系统由火灾报警主机和编码型烟雾传感器、手动报警按钮、声光报警器等组成，系统采用电子编码式烟雾传感器采集隧道内实时环境状态，当产生火警信号时，把信号上传至安全主机及环境综合监控软件。安全主机及环境综合监控软件接收到火警信息后，相应采取一系列措施，如联动风机、联动声光报警等，并把火警信号进一步转发上传至调度端平台。

Keyword:

Power IoT sensors Smart power distribution Internet of Things Smart cable tunnel gallery Smart power generation Internet of Things Smart Internet of Things

Category:

电缆隧道综合监控系统

Free consultation telephone:

0519-85851518

Message

隧道综合监控系统/综合管廊监控系统———火灾自动报警系统

系统介绍

火灾自动报警系统由火灾报警主机和编码型烟雾传感器、手动报警按钮、声光报警器等组成，系统采用电子编码式烟雾传感器采集隧道内实时环境状态，当产生火警信号时，把信号上传至安全主机及环境综合监控软件。安全主机及环境综合监控软件接收到火警信息后，相应采取一系列措施，如联动风机、联动声光报警等，并把火警信号进一步转发上传至调度端平台。

主机介绍

火灾自动报警4.jpg

火灾报警控制器（联动型）采用壁挂式结构，其主要特点如下：

　　1、本控制器为小点数系列产品，有多种容量配置方式可供选择；

　　2、不论对联动类还是报警类总线设备，控制器都设有不掉电备份，保证系统调试完成时注册到的设备全部受到监控；

　　3、本控制器开机自检时，不仅自动检测本机设备（指示灯、功能键等），同时还逐条检测外部设备的注册信息及联动公式信息，如信息发生变化系统将做相应的处理；

　　4、本控制器最多可配置6路多线制控制卡，控制卡不需与GST-LD-8302C切换模块配接使用就可实现对输出线断路、短路检测功能，这些检测功能可最大限度的保障控制模块本身及其与重要设备之间连接的可靠性；

　　5、本控制器对具有特殊重要意义的气体喷洒设备提供了独立的控制密码和联动编程空间，并有相应的声光指示，使气体喷洒设备受到了更严格的监控；

　　6、本控制器可外接火灾报警显示盘及彩色CRT显示系统并标配手动盘及多线制控制卡等设备，满足各种系统配置要求；

　　7、本控制器具有强大的面板控制及操作功能，各种功能设置全面、简单、方便；

　　8、本控制器采用全模具化结构，外形美观。

主要技术参数

液晶屏规格	240×160点，可同屏显示150个汉字信息
控制器容量	a.最大容量为242个地址编码点 b.可外接64台火灾显示盘；联网时最多可接32台其它类型控制器 c.30个直接手动操作总线制控制点 d.配置6个多线制控制点
线制	a.控制器与探测器间采用无极性信号二总线连接 b.多线制控制点与现场设备采用四线直接连接，其中两线用于控制启停设备，另两线用于接收现场设备的反馈信号，输出控制和反馈输入均具有检线功能 c.控制器与各类编码模块采用四总线连接（无极性信号二总线、无极性DC24V电源线） d.控制器与火灾显示盘采用四总线连接（有极性通讯二总线、无极性DC24V电源线） e.与彩色CRT系统通过RS-232标准接口连接，最大连接线长度不宜超过15m
使用环境	温度：0℃～+40℃ 相对湿度≤95%，不结露
电源	主电为交流220V电压变化范围＋10%～－15%，内装DC12V10Ah密封铅电池作备电
功耗	≤25W
外形尺寸	380mm×143mm×534mm

Related Products

Maintenance-free intelligent transformer breather

The maintenance-free transformer breather is an air dehumidification and purification device used for oil-immersed transformers, instrument transformers, on-load tap changers, or other electrical equipment filled with insulating liquid. The maintenance-free transformer breather is installed at the air inlet of the instrument transformer's oil storage tank. When the transformer or instrument transformer operates, the oil volume changes due to temperature variations, causing the gas inside the oil storage tank to breathe through the desiccant. Air passes through the filter at the bottom of the desiccant and the glass jar filled with silica gel into the transformer, ensuring that the inhaled air is dry (moisture is adsorbed by the desiccant) and clean (dust and impurities are blocked by the filter), thereby maintaining the cleanliness and insulation strength of the transformer oil.

JC-OM700-EE Wireless Expansion Joint Sensor

The JC-OM700-EE wireless expansion joint sensor achieves online monitoring of expansion joint compensation by modifying the existing mechanical vernier caliper of GIS/GIL expansion joints or adding a digital expansion joint displacement sensor. The wireless expansion joint sensor uses a high-speed ARM chip as the main controller and a high-precision displacement sensor to sample and calculate the displacement data of the measured object in real time. It can upload data to the host computer via wireless LoRa and wired RS485.

Current monitoring sensor of arrester in switchgear

Full current measurement range: 0.050 ~ 5.000mA Full current measurement error: ± (standard reading ×1%+5μA) Record the cumulative discharge times :0 ~ 99 times Power supply: DC24V Communication interface: RS-485

Ground resistance sensor

Power supply: dc6 ～ 12V Range: 0.01 Ω- two hundred Ω Accuracy: ± 2%rdg ± 3dgt(20℃ ± 5 ℃, below 70% RH) Communication mode: RS485 Protection grade: IP54

High frequency current sensor

Sensitivity: 5pc Detection frequency band: 50KHz ～ 100MHz Signal output: RS485 Installation position: cable connector ground wire Installation mode: clamp type, clamping

Tilt sensor

Range: ± thirty ° Voltage: 9-35v Output mode: RS485 IP67 protection level

Infrared thermal imaging camera of switch cabinet

Thermal imaging resolution: 160 * 120 Visible light resolution: 200W Power supply: dc12-24 V Temperature range: - 20 ℃ ~ 150 ℃ Accuracy: ± 2 ℃ or 2% of the reading (take the maximum absolute value)

Space UHF PD sensor

Detection frequency band: 300 ~ 1500mhz Protection grade: IP65 Collect the discharge amplitude and phase The service life is more than 8 years

Micro weather sensor

Temperature: measuring range - 40 ~ 60 ℃ ° C Accuracy ± zero point one ° C； two Temperature: measurement range 0 ~ 100% RH Air pressure: measuring range: 10 ~ 1300 Wind speed measurement range: 0-75 M / S

Switch cabinet partial discharge sensor (UHF)

The system adopts UHF principle to conduct local discharge monitoring of high voltage switchgear to ensure the effective monitoring data, and increase system reliability. Ultra low power consumption and 485 bus communication mode are adopted. It is applicable to switch cabinet and ring network cabinet. Each cabinet is equipped with one set to realize the power / qualitative measurement of local discharge. It can be directly connected to the system host without the limitation of host channel.)

Switch cabinet partial discharge sensor (UHF + AE two in one)

The system adopts UHF + AE principle Ultra low power consumption and 485 bus communication mode are adopted, It is suitable for switch cabinet and ring main unit to realize the quantity / qualitative measurement of partial discharge

Intelligent air conditioning / dehumidification linkage device

AC / dc220v power supply is adopted Allowable deviation - 20% ～ + 20% Control output node capacity: AC / dc220v, ≥ 8A Support 2-4 independent node output capability