高频电流局放在线监测装置-Jiangsu jotry Electric Technology Co., Ltd.

高频电流局放在线监测装置

电感型传感器中的高频电流局放在线监测装置具有便携性强、安装方便、现场抗干扰能力较好等优点。因此影厂最为广泛，其工作方式是对刘静电力设备的接地线、中性点接线及电缆本体中放电脉冲电流信号进行检测。

Keyword:

Power IoT sensors Smart power distribution Internet of Things Smart cable tunnel gallery Smart power generation Internet of Things Smart Internet of Things

Category:

变电物联网协议无线传感器

Free consultation telephone:

0519-85851518

Message

高频电流局放在线监测装置

产品概述

高频局部放电检测方法是用于电力设备局部放电缺陷检测与定于的常用测量方法之一，其检测频率范围通常在3-30MHz之间，高频局部放电监测技术可广泛应用于电力电缆及其附件、变压器、电抗器、旋转电机等电力设备的局放检测，其高频脉冲电流信号由电感式耦合传感器进行耦合。

高频电流局放在线监测装置（High Frequency Current Transformer 简称HFCT）具有便携性强、安装方便、现场抗干扰能力较好等优点。因此影厂最为广泛，其工作方式是对刘静电力设备的接地线、中性点接线及电缆本体中放电脉冲电流信号进行检测。

高频电流局放在线监测装置.jpg

技术优势

1、可进行局部放电强度的量化描述

2、具有便于携带、方便应用、性价比高等优点

3、检测灵敏度较高，高频电流传感器一般由环形铁氧体磁芯构成，铁氧体配合经磁化处理的陶瓷材料，对于高频信号具有很高灵敏度，局部放电发生后，放电脉冲电流将沿着接地线的轴向方向传播，即会在垂直于电流传播方向的平面上产生磁场，电感型传感器是从该磁场中耦合放电信号。

产品原理

高频电流传感器其有效的频率监测范围一般为3-30MHz，由于所测量的局部放电信号是微弱高频电流信号，传感器需要在较宽的频带内有较高的灵敏度，因此HFCT选用高磁导率的磁芯作为线圈骨架。常用的高频局部放电监测装置包括传感器、信号处理单元、信号采集段元、数据处理终端，高频局部放电监测装置结构框图如下图所示。

高频电流局放系统架构图.png

1、传感器

高频局部放电监测HFCT传感器按安装位置不同主要分为接地线HFCT和电缆本体HFCT，安装在电力设备接地线或电缆交叉互联系统的HFCT传感器，内径一般为即使毫米，本设备采用分体式HFCT高频电流传感器，线圈可开合，方便测试安装和拆卸，可以使用一个传感器对设备多个位置进行测量。

2、信号处理单元

针对传感器的输出信号，需要进行滤波和放大，实际测量中会有各类噪声和干扰信号，因此需要配合硬件滤波或后续数字滤波功能进行滤波，滤波后信号幅值会有一定程度的衰减，续集干过宽带放电器放大，从而达到提高局部放电信号信噪比的目的。

3、信号采集单元

将实际采集到的模拟信号转换为可供进一步处理的数字信号。

4、数据处理终端

将实际采集到的数字信号经过进一步的算法处理，通过网口或RS485通讯接口，将数据上传到终端显示平台进行显示。

技术参数

适用范围	电流电缆、变压器
供电电压	220AC
局放灵敏度	小于100pC（实验室环境下）
使用寿命	大于5年
通道数	3路HFCT信号采集
通讯方式	RS-485
安装方式	卡扣式安装
检测原理	HFCT
测量范围	-80--20dbm
分辨率	1dbm
频率带宽	3-30MHz

Related Products

Maintenance-free intelligent transformer breather

The maintenance-free transformer breather is an air dehumidification and purification device used for oil-immersed transformers, instrument transformers, on-load tap changers, or other electrical equipment filled with insulating liquid. The maintenance-free transformer breather is installed at the air inlet of the instrument transformer's oil storage tank. When the transformer or instrument transformer operates, the oil volume changes due to temperature variations, causing the gas inside the oil storage tank to breathe through the desiccant. Air passes through the filter at the bottom of the desiccant and the glass jar filled with silica gel into the transformer, ensuring that the inhaled air is dry (moisture is adsorbed by the desiccant) and clean (dust and impurities are blocked by the filter), thereby maintaining the cleanliness and insulation strength of the transformer oil.

JC-OM700-EE Wireless Expansion Joint Sensor

The JC-OM700-EE wireless expansion joint sensor achieves online monitoring of expansion joint compensation by modifying the existing mechanical vernier caliper of GIS/GIL expansion joints or adding a digital expansion joint displacement sensor. The wireless expansion joint sensor uses a high-speed ARM chip as the main controller and a high-precision displacement sensor to sample and calculate the displacement data of the measured object in real time. It can upload data to the host computer via wireless LoRa and wired RS485.

Current monitoring sensor of arrester in switchgear

Full current measurement range: 0.050 ~ 5.000mA Full current measurement error: ± (standard reading ×1%+5μA) Record the cumulative discharge times :0 ~ 99 times Power supply: DC24V Communication interface: RS-485

Ground resistance sensor

Power supply: dc6 ～ 12V Range: 0.01 Ω- two hundred Ω Accuracy: ± 2%rdg ± 3dgt(20℃ ± 5 ℃, below 70% RH) Communication mode: RS485 Protection grade: IP54

High frequency current sensor

Sensitivity: 5pc Detection frequency band: 50KHz ～ 100MHz Signal output: RS485 Installation position: cable connector ground wire Installation mode: clamp type, clamping

Tilt sensor

Range: ± thirty ° Voltage: 9-35v Output mode: RS485 IP67 protection level

Infrared thermal imaging camera of switch cabinet

Thermal imaging resolution: 160 * 120 Visible light resolution: 200W Power supply: dc12-24 V Temperature range: - 20 ℃ ~ 150 ℃ Accuracy: ± 2 ℃ or 2% of the reading (take the maximum absolute value)

Space UHF PD sensor

Detection frequency band: 300 ~ 1500mhz Protection grade: IP65 Collect the discharge amplitude and phase The service life is more than 8 years

Micro weather sensor

Temperature: measuring range - 40 ~ 60 ℃ ° C Accuracy ± zero point one ° C； two Temperature: measurement range 0 ~ 100% RH Air pressure: measuring range: 10 ~ 1300 Wind speed measurement range: 0-75 M / S

Switch cabinet partial discharge sensor (UHF)

The system adopts UHF principle to conduct local discharge monitoring of high voltage switchgear to ensure the effective monitoring data, and increase system reliability. Ultra low power consumption and 485 bus communication mode are adopted. It is applicable to switch cabinet and ring network cabinet. Each cabinet is equipped with one set to realize the power / qualitative measurement of local discharge. It can be directly connected to the system host without the limitation of host channel.)

Switch cabinet partial discharge sensor (UHF + AE two in one)

The system adopts UHF + AE principle Ultra low power consumption and 485 bus communication mode are adopted, It is suitable for switch cabinet and ring main unit to realize the quantity / qualitative measurement of partial discharge

Intelligent air conditioning / dehumidification linkage device

AC / dc220v power supply is adopted Allowable deviation - 20% ～ + 20% Control output node capacity: AC / dc220v, ≥ 8A Support 2-4 independent node output capability