智能综合气体检测器_Jiangsu jotry Electric Technology Co., Ltd.

智能综合气体检测器

适应于工业环境（尤其是地下管廊）中甲烷（CH4）、氧气(O2)、一氧化碳(CO)、硫化氢(H2S)和氢气(H2)的浓度以及温湿度检测。

Keyword:

Power IoT sensors Smart power distribution Internet of Things Smart cable tunnel gallery Smart power generation Internet of Things Smart Internet of Things

Category:

常规变电物联网传感器

Free consultation telephone:

0519-85851518

Message

智能综合气体检测器

产品概述

智能综合气体检测器是我公司生产的新型气体检测仪器，本机采用高性能催化燃烧气敏元器件和微控制器技术，结合精良SMD工艺制造而成，具有良好的重复性和温湿度特性、使用寿命长、操作方便等优点。适应于工业环境（尤其是地下管廊）中甲烷（CH4）、氧气(O2)、一氧化碳(CO)、硫化氢(H2S)和氢气(H2)的浓度以及温湿度检测。

智能综合气体检测器将空气中气体浓度信号转化为数字信号,并配有RS485接口和WIFI传输功能。只需通过RS485接口或者WIFI信号即可访问检测器中测得的气体浓度和温湿度数据（可根据需求定制）。

有毒气体、氧气、二氧化碳、易燃易爆类气体、TVOC等，多种气体随意组合。

选配：最多可同时检测任意1～6种气体和温湿度。0～1、10、100、1000、5000、50000、100000ppm、200毫克/升、100%LEL、20%、50%、99.999%、100%Vol可选，其他量程可订制。电化学、催化燃烧、红外、热导、PID光离子等，根据气体类型、量程、现场环境和用户需求而定。

技术参数

检测原理：甲烷：红外;
氧气、一氧化碳、硫化氢、氢气、温度、湿度：电化学;

检测气体：甲烷（CH4）;氧气(O2);一氧化碳(CO);硫化氢(H2S);氢气(H2);

采样方式：自然扩散;

测试范围：甲烷： 0-100%LEL;

氧气： 0-25%VOL;

一氧化碳： 0-1000ppm;

硫化氢： 0-100ppm;

氢气： 0-1000ppm;

温度： -40~125℃

湿度： 0-100%

分辨率：甲烷： 1%LEL;

氧气： 0.1%VOL;

一氧化碳： 1ppm;

硫化氢： 1ppm;

氢气： 1ppm;

温度： 0.1℃

湿度： 0.1%

测量误差：甲烷： ±3%FS;

氧气： ±1%FS;

一氧化碳： ±10%FS;

硫化氢： ±10%FS;

氢气: ±10%FS

温度: ±0.3℃

湿度： ±0.2%

预期寿命： 2年（出厂日开始计算）

状态指示：LED、数码管显示（可定制）;

调试方式：PC机、手机等;

响应时间：＜30s;

恢复时间：＜30s;

环境温度：－20℃～50℃;

相对湿度：＜95%;

防爆方式：隔爆型;

防爆等级：ExeIICT6Gb;

防护等级：IP65;

电源：DC24V;

输出信号：RS485;WIFI（2.4G）;

功耗：≤10W;

整机重量：≤2Kg;

压力限制：86kPa～106kPa；

使用场所：在具有爆炸性可燃气体IIA~IIC级，温度组别为T1~T6的危险场所使用

Related Products

Current monitoring sensor of arrester in switchgear

Full current measurement range: 0.050 ~ 5.000mA Full current measurement error: ± (standard reading ×1%+5μA) Record the cumulative discharge times :0 ~ 99 times Power supply: DC24V Communication interface: RS-485

Ground resistance sensor

Power supply: dc6 ～ 12V Range: 0.01 Ω- two hundred Ω Accuracy: ± 2%rdg ± 3dgt(20℃ ± 5 ℃, below 70% RH) Communication mode: RS485 Protection grade: IP54

High frequency current sensor

Sensitivity: 5pc Detection frequency band: 50KHz ～ 100MHz Signal output: RS485 Installation position: cable connector ground wire Installation mode: clamp type, clamping

Tilt sensor

Range: ± thirty ° Voltage: 9-35v Output mode: RS485 IP67 protection level

Infrared thermal imaging camera of switch cabinet

Thermal imaging resolution: 160 * 120 Visible light resolution: 200W Power supply: dc12-24 V Temperature range: - 20 ℃ ~ 150 ℃ Accuracy: ± 2 ℃ or 2% of the reading (take the maximum absolute value)

Space UHF PD sensor

Detection frequency band: 300 ~ 1500mhz Protection grade: IP65 Collect the discharge amplitude and phase The service life is more than 8 years

Micro weather sensor

Temperature: measuring range - 40 ~ 60 ℃ ° C Accuracy ± zero point one ° C； two Temperature: measurement range 0 ~ 100% RH Air pressure: measuring range: 10 ~ 1300 Wind speed measurement range: 0-75 M / S

Switch cabinet partial discharge sensor (UHF)

The system adopts UHF principle to conduct local discharge monitoring of high voltage switchgear to ensure the effective monitoring data, and increase system reliability. Ultra low power consumption and 485 bus communication mode are adopted. It is applicable to switch cabinet and ring network cabinet. Each cabinet is equipped with one set to realize the power / qualitative measurement of local discharge. It can be directly connected to the system host without the limitation of host channel.)

Switch cabinet partial discharge sensor (UHF + AE two in one)

The system adopts UHF + AE principle Ultra low power consumption and 485 bus communication mode are adopted, It is suitable for switch cabinet and ring main unit to realize the quantity / qualitative measurement of partial discharge

Intelligent air conditioning / dehumidification linkage device

AC / dc220v power supply is adopted Allowable deviation - 20% ～ + 20% Control output node capacity: AC / dc220v, ≥ 8A Support 2-4 independent node output capability

Intelligent light control unit

Output mode: switch type, realize local and remote control of lighting Wall mounted / 2U rack mounted Using brand devices to ensure reliability Size (mm): 480mm long × 85mm wide × 340mm deep

Intelligent water pump control unit

Output mode: switch type, realize the linkage control of water pump Wall mounted / 2U rack mounted, Using brand devices to ensure reliability Size (mm): 480mm long × 85mm wide × 340mm deep