无线臭氧传感器

无线臭氧传感器采用进口传感器,测量精度高,支持无线信号传输,输出性能稳定,使用寿命长,硬件设计上采用先进的单片微机,减少外围部件,提高系统的可靠性和稳定性.

Keyword:

Power IoT sensors Smart power distribution Internet of Things Smart cable tunnel gallery Smart power generation Internet of Things Smart Internet of Things

Free consultation telephone:

Product Details

融合终端配套无线传感器———无线臭氧传感器


 

产品概述


    无线臭氧传感器采用进口传感器,测量精度高,支持无线信号传输,输出性能稳定,使用寿命长,硬件设计上采用先进的单片微机,减少外围部件,提高系统的可靠性和稳定性.

 

产品特征

 

    1、 实时监测环境臭氧值

    2、 采用进口传感器,测量精确可靠

    3、 支持无线LoRa通讯(470MHz或2.4GHz)

    4、 抗干扰性强

    5、 安装灵活方便


 

技术参数


    1、 电源:①采用电池供电,电池容量≥1200mAh(在1次/15分钟频次下正常工作5年以上)

              ②采用AC/DC220V供电,允许偏差-20%~+20%。

    2、 O3测量范围:0~20ppm;

    3、 O3精度:<±0.1ppm(25℃);

    4、 通信方式:LoRa无线通信(470MHz或2.4GHz)

    5、 无线传输距离:>50米

    6、 数据上送频率:数据上送频率:出厂配置1次/15分钟,可配置范围1次/分钟至1次/60分钟。

    7、 使用年限:≥5年;

    8、 结构防护等级满足IP40防护等级要求;

    9、 安装方式:采用螺钉或卡扣安装。

 

 

Related Products

Current monitoring sensor of arrester in switchgear


Full current measurement range: 0.050 ~ 5.000mA Full current measurement error: ± (standard reading ×1%+5μA) Record the cumulative discharge times :0 ~ 99 times Power supply: DC24V Communication interface: RS-485

Ground resistance sensor


Power supply: dc6 ~ 12V Range: 0.01 Ω- two hundred Ω  Accuracy: ± 2%rdg ± 3dgt(20℃ ± 5 ℃, below 70% RH) Communication mode: RS485 Protection grade: IP54

High frequency current sensor


Sensitivity: 5pc Detection frequency band: 50KHz ~ 100MHz Signal output: RS485 Installation position: cable connector ground wire Installation mode: clamp type, clamping

Tilt sensor


Range: ± thirty °  Voltage: 9-35v Output mode: RS485 IP67 protection level

Infrared thermal imaging camera of switch cabinet


Thermal imaging resolution: 160 * 120 Visible light resolution: 200W Power supply: dc12-24 V Temperature range: - 20 ℃ ~ 150 ℃ Accuracy: ± 2 ℃ or 2% of the reading (take the maximum absolute value)

Space UHF PD sensor


Detection frequency band: 300 ~ 1500mhz Protection grade: IP65 Collect the discharge amplitude and phase The service life is more than 8 years

Micro weather sensor


Temperature: measuring range - 40 ~ 60 ℃ ° C Accuracy ± zero point one ° C; two Temperature: measurement range 0 ~ 100% RH Air pressure: measuring range: 10 ~ 1300 Wind speed measurement range: 0-75 M / S

Switch cabinet partial discharge sensor (UHF)


The system adopts UHF principle to conduct local discharge monitoring of high voltage switchgear to ensure the effective monitoring data, and increase system reliability. Ultra low power consumption and 485 bus communication mode are adopted. It is applicable to switch cabinet and ring network cabinet. Each cabinet is equipped with one set to realize the power / qualitative measurement of local discharge. It can be directly connected to the system host without the limitation of host channel.)

Switch cabinet partial discharge sensor (UHF + AE two in one)


The system adopts UHF + AE principle Ultra low power consumption and 485 bus communication mode are adopted, It is suitable for switch cabinet and ring main unit to realize the quantity / qualitative measurement of partial discharge

Intelligent air conditioning / dehumidification linkage device


AC / dc220v power supply is adopted Allowable deviation - 20% ~ + 20% Control output node capacity: AC / dc220v, ≥ 8A Support 2-4 independent node output capability

Intelligent light control unit


Output mode: switch type, realize local and remote control of lighting Wall mounted / 2U rack mounted Using brand devices to ensure reliability Size (mm): 480mm long × 85mm wide × 340mm deep

Intelligent water pump control unit


Output mode: switch type, realize the linkage control of water pump Wall mounted / 2U rack mounted, Using brand devices to ensure reliability Size (mm): 480mm long × 85mm wide × 340mm deep

Welcome your message consultation

Our staff will contact you within 24 hours (weekdays), if you need other services, please call the service hotline:0519-85851518