牵引变电所智能辅助控制系统

牵引变电所智能辅助控制系统对变电站内环境中有毒有害气体含量、O2含量、温湿度、入侵、的状态进行监控,并根据预先设置的启动方式,监测设备的状态,分别对空调、照明、水泵、通风机等设备进行控制。同时,也可以引入火灾、烟雾等信号进行联动。另外还具有实时监测高压一次设备母排温度、变压器温度监测、开关柜内局放监测等功能。

Keyword:

Power IoT sensors Smart power distribution Internet of Things Smart cable tunnel gallery Smart power generation Internet of Things Smart Internet of Things

Free consultation telephone:

Product Details

牵引变电所智能辅助控制系统 
 

系统概述

 

  近年来国家大力发展智能电网,输变电系统的智能化信息化已具备相当高的水平,而配网由于其使用环境和结构的复杂性使得智能化信息化水平较低,随着智能电网工作的进一步深入,配网智能化信息化已成为下一步的主要工作之一,国家电网于2011年把配网智能监测列入技术导则,但是由于存在信息采集种类繁多,缺少传输通道,缺少综合的主站软件等原因,国内尚无该类应用。

针对这一问题,利用现代最新的计算机技术、网络技术、图像技术、安防监控和防盗报警、安全环境综合监控技术,推出变电站综合在线监控系统,对变电站实施全面的集中监测监控管理。

   牵引变电所智能辅助控制系统对变电站内环境中有毒有害气体含量、O2含量、温湿度、入侵、的状态进行监控,并根据预先设置的启动方式,监测设备的状态,分别对空调、照明、水泵、通风机等设备进行控制。同时,也可以引入火灾、烟雾等信号进行联动。另外还具有实时监测高压一次设备母排温度、变压器温度监测、开关柜内局放监测等功能。变电站各被监测点的现场实际状态通过网络传输到调度中心,局领导及调度人员可在调度中心查看各个变电站的情况,减少了巡检人员强度,加强对变电站等的安全、保卫、火警监视,保障变电站安全运行。

系统架构图





 

应用场景图



 

选配方案





选配方案一:标准屏柜式(为设计院典型设计和配置)

主要功能/特点:

      1、标准屏柜 高端大气

      2、机架式4U主机带7寸彩色触摸屏

      3、可进行3D建模,可视化效果更好

      4、可实现配电房的环境、设备状态、安防、消防、视频等综合监控

 

选配方案二:标准机柜式(适用于配电房智能化新建或改造项目,尤其是空间有限的改造项目,能实现包括视频在内的各种智能化需求)


主要功能/特点:

1、具备方案一的全部功能

2、外置7寸或10寸触摸屏,简单大气,有较好体验

3、具有视频监控功能,集成度高,体积紧凑

4、功能齐全 满足所有智能化需求

选配方案三:壁挂式(适用于预算较低,有初步智能化需求,便于大量推广)

主要功能/特点:

1、一体式设计 集成度高

2、具有新风、除湿防凝露、降温(可选)等综合功能

3、具有烟雾、水浸、温湿度、SF6、氧气等功能,同时可以门禁(门磁)、视频等功能,并可增加人脸识别等功能,可远程运维,可选配APP功能。


选配方案四:运行环境智能调控装置(适用于沿海、沿江、山区等湿度较大地区,具备风道(可选)、除湿、调温(可选)及各种环境传感器的采集和设备联动控制功能)

主要功能/特点:

1、一体式设计集成度高

2、具有智能化控制、24小时通风降温、除湿防凝露、实时通信、基于WEB的远程维护、人机信息互动、智能调温(可选配)、风道(可选配)等综合功能

3、具有监测烟雾、水浸、温湿度、SF6、氧气等功能,同时可以门禁(门磁)、视频等功能,并可增加人脸识别等功能,可远程运维,可选配APP功能。

Related Products

Current monitoring sensor of arrester in switchgear


Full current measurement range: 0.050 ~ 5.000mA Full current measurement error: ± (standard reading ×1%+5μA) Record the cumulative discharge times :0 ~ 99 times Power supply: DC24V Communication interface: RS-485

Ground resistance sensor


Power supply: dc6 ~ 12V Range: 0.01 Ω- two hundred Ω  Accuracy: ± 2%rdg ± 3dgt(20℃ ± 5 ℃, below 70% RH) Communication mode: RS485 Protection grade: IP54

High frequency current sensor


Sensitivity: 5pc Detection frequency band: 50KHz ~ 100MHz Signal output: RS485 Installation position: cable connector ground wire Installation mode: clamp type, clamping

Tilt sensor


Range: ± thirty °  Voltage: 9-35v Output mode: RS485 IP67 protection level

Infrared thermal imaging camera of switch cabinet


Thermal imaging resolution: 160 * 120 Visible light resolution: 200W Power supply: dc12-24 V Temperature range: - 20 ℃ ~ 150 ℃ Accuracy: ± 2 ℃ or 2% of the reading (take the maximum absolute value)

Space UHF PD sensor


Detection frequency band: 300 ~ 1500mhz Protection grade: IP65 Collect the discharge amplitude and phase The service life is more than 8 years

Micro weather sensor


Temperature: measuring range - 40 ~ 60 ℃ ° C Accuracy ± zero point one ° C; two Temperature: measurement range 0 ~ 100% RH Air pressure: measuring range: 10 ~ 1300 Wind speed measurement range: 0-75 M / S

Switch cabinet partial discharge sensor (UHF)


The system adopts UHF principle to conduct local discharge monitoring of high voltage switchgear to ensure the effective monitoring data, and increase system reliability. Ultra low power consumption and 485 bus communication mode are adopted. It is applicable to switch cabinet and ring network cabinet. Each cabinet is equipped with one set to realize the power / qualitative measurement of local discharge. It can be directly connected to the system host without the limitation of host channel.)

Switch cabinet partial discharge sensor (UHF + AE two in one)


The system adopts UHF + AE principle Ultra low power consumption and 485 bus communication mode are adopted, It is suitable for switch cabinet and ring main unit to realize the quantity / qualitative measurement of partial discharge

Intelligent air conditioning / dehumidification linkage device


AC / dc220v power supply is adopted Allowable deviation - 20% ~ + 20% Control output node capacity: AC / dc220v, ≥ 8A Support 2-4 independent node output capability

Intelligent light control unit


Output mode: switch type, realize local and remote control of lighting Wall mounted / 2U rack mounted Using brand devices to ensure reliability Size (mm): 480mm long × 85mm wide × 340mm deep

Intelligent water pump control unit


Output mode: switch type, realize the linkage control of water pump Wall mounted / 2U rack mounted, Using brand devices to ensure reliability Size (mm): 480mm long × 85mm wide × 340mm deep

Welcome your message consultation

Our staff will contact you within 24 hours (weekdays), if you need other services, please call the service hotline:0519-85851518