水位传感器JC-SW-ZN03

本产品广泛应用于电力配电房、电缆沟井、水厂、污水处理厂等工业领域，实现对液体、气体、蒸汽压力的测量。

Keyword:

Power IoT sensors Smart power distribution Internet of Things Smart cable tunnel gallery Smart power generation Internet of Things Smart Internet of Things

Category:

无线LoRa传感器

Free consultation telephone:

0519-85851518

Message

水位传感器

产品概述

水位传感器采用高性能的感压芯片，配合先进的电路处理和温度补偿技术，将压力变化转化为线性的电流或电压信号。产品体积小巧，易于安装，采用不锈钢外壳隔离防腐，适于测量与接触部分材质相兼容的气体和流体等介质，它可以用来测量表压、负压和绝压。产品是在通用压力变送器原型基础上，加装焊接密封隔离膜片结构而形成的。它的焊接密封隔离膜片装置具有多种不同过程连接结构形式，特别适用于高温、高粘度、结晶状介质及易堵塞场合的压力测量，也适用于电力环境、卫生、医药场合的水位测量。传感器支持RS485/LORA无线数据上传。

无线<strong>水位传感器</strong>水印版.jpg

应用场合

本产品广泛应用于电力配电房、电缆沟井、水厂、污水处理厂等工业领域，实现对液体、气体、蒸汽压力的测量。

产品特点

具有反向极性和限流保护；激光调阻温度补偿；可程控调节；抗振动、抗冲击，防射频电磁干扰：过载及抗gan扰能力强，经济实用稳定。

技术参数

● 工作电源

根据买方要求以下供电方式二选一：

a) 采用电池供电，电池容量不低于1200mAh，且在1次/15分钟频次下正常工作5年以上；

b) 采用AC/DC220V供电，允许偏差-20%～+20%。

● 结构

结构防护等级：数据汇集器不低于IP40，传感采集器不低于IP67。采用螺钉或卡扣安装。

● 技术参数

a) 水位检测量程： 0m～3m；

b) 水位精度:0.5%FS；

a) 使用年限：≥5年。

● 通信

a) 通信方式：采用基于LoRa的2.4GHz频段无线通信，满足输变电设备物联网微功率无线网通信协议。或者采用基于LoRa的470MHz频段无线通信，满足输变电设备物联网节点设备无线组网协议。

b) 无线传输距离：大于50米；

c) 数据上送频率：数据上送频率：出厂配置1次/15分钟，可配置范围1次/分钟至1次/60分钟。

产品通过国网电科院权威检测

Related Products

Current monitoring sensor of arrester in switchgear

Full current measurement range: 0.050 ~ 5.000mA Full current measurement error: ± (standard reading ×1%+5μA) Record the cumulative discharge times :0 ~ 99 times Power supply: DC24V Communication interface: RS-485

Ground resistance sensor

Power supply: dc6 ～ 12V Range: 0.01 Ω- two hundred Ω Accuracy: ± 2%rdg ± 3dgt(20℃ ± 5 ℃, below 70% RH) Communication mode: RS485 Protection grade: IP54

High frequency current sensor

Sensitivity: 5pc Detection frequency band: 50KHz ～ 100MHz Signal output: RS485 Installation position: cable connector ground wire Installation mode: clamp type, clamping

Tilt sensor

Range: ± thirty ° Voltage: 9-35v Output mode: RS485 IP67 protection level

Infrared thermal imaging camera of switch cabinet

Thermal imaging resolution: 160 * 120 Visible light resolution: 200W Power supply: dc12-24 V Temperature range: - 20 ℃ ~ 150 ℃ Accuracy: ± 2 ℃ or 2% of the reading (take the maximum absolute value)

Space UHF PD sensor

Detection frequency band: 300 ~ 1500mhz Protection grade: IP65 Collect the discharge amplitude and phase The service life is more than 8 years

Micro weather sensor

Temperature: measuring range - 40 ~ 60 ℃ ° C Accuracy ± zero point one ° C； two Temperature: measurement range 0 ~ 100% RH Air pressure: measuring range: 10 ~ 1300 Wind speed measurement range: 0-75 M / S

Switch cabinet partial discharge sensor (UHF)

The system adopts UHF principle to conduct local discharge monitoring of high voltage switchgear to ensure the effective monitoring data, and increase system reliability. Ultra low power consumption and 485 bus communication mode are adopted. It is applicable to switch cabinet and ring network cabinet. Each cabinet is equipped with one set to realize the power / qualitative measurement of local discharge. It can be directly connected to the system host without the limitation of host channel.)

Switch cabinet partial discharge sensor (UHF + AE two in one)

The system adopts UHF + AE principle Ultra low power consumption and 485 bus communication mode are adopted, It is suitable for switch cabinet and ring main unit to realize the quantity / qualitative measurement of partial discharge

Intelligent air conditioning / dehumidification linkage device

AC / dc220v power supply is adopted Allowable deviation - 20% ～ + 20% Control output node capacity: AC / dc220v, ≥ 8A Support 2-4 independent node output capability

Intelligent light control unit

Output mode: switch type, realize local and remote control of lighting Wall mounted / 2U rack mounted Using brand devices to ensure reliability Size (mm): 480mm long × 85mm wide × 340mm deep

Intelligent water pump control unit

Output mode: switch type, realize the linkage control of water pump Wall mounted / 2U rack mounted, Using brand devices to ensure reliability Size (mm): 480mm long × 85mm wide × 340mm deep