智能巡检控制系统-Jiangsu jotry Electric Technology Co., Ltd.

智能巡检控制系统

智能巡检控制系统是专为开闭所、配电房智能远程巡检管理服务的新一代智能产品，它集现代移动通信技术、计算机技术、电力测量技术于一身，实现配变异常远程告警，加强了电力部门技术远程巡检能力，生成电力部门的各项管理数据、分析曲线、报表等，为电力部门细化管理提供了科学的、先进的技术手段。

Keyword:

Power IoT sensors Smart power distribution Internet of Things Smart cable tunnel gallery Smart power generation Internet of Things Smart Internet of Things

Category:

常规配电物联网传感器

Free consultation telephone:

0519-85851518

Message

智能巡检控制系统

产品概述

智能巡检控制系统是专为开闭所、配电房智能远程巡检管理服务的新一代智能产品，它集现代移动通信技术、计算机技术、电力测量技术于一身，实现配变异常远程告警，加强了电力部门技术远程巡检能力，生成电力部门的各项管理数据、分析曲线、报表等，为电力部门细化管理提供了科学的、先进的技术手段。用于监测配电变压器，配电线路运行状态和补偿配电网无功的终端单元，以数字信号处理器DSP为核心，具有实时数据采集，电量计量，历史数据存储，故障告警功能。采用液晶显示屏就地显示运行状态，适用于低压电网运行状态监测和低压动态无功补偿等场合。可以通过监视变压器的运行状况，优化配网运行方式；发生故障或异常运行时，迅速告警，及时恢复正常供电，减少停电时间，保证变压器的安全运行；记录电压越限时间，计算电压合格率，从而合理控制电平水平，改善供电质量。

技术参数

1、工作电压：AC220V；

2、开关量采集通道数8，干接点输入；

3、开关量输出通道数8，干接点输出；

4、通信通道数：6路RS485，1路RS232；

5、GPRS短信收发功能；

6、具有掉电保护功能，能够保存配置信息、历史数据和告警信息；

7、电源、运行、告警和串口收发指示；

8、具有看门狗功能，使系统稳定可靠运行。

9、具备B码对时功能；

10、工作环境：温度:-25 ℃～＋70 ℃ 湿度:≤95％RH

11、绝缘性能：外壳与电源间：>10MΩ

12、电磁兼容特性：快速瞬变脉冲群 GB/T17626.4-1999 4级

环境监控子系统及运行联动

主要通过监控主机读取房内温湿度、烟感、水浸、氧气、臭氧、SF6等传感器,根据预设的上下限定值,启动空调、除湿器、风机、水泵等,及时智慧治理，使超标项目快速恢复正常，保证配电站所环境持续合格达标，满足正常工作环境。同时监控主机实时上报当前的环境参数,在超出预设定值后,及时上告告警信号。

安防子系统及运行联动

传感器收集数据→监控主机→智能管理平台→通知相关人员并联动控制

视频子系统及联动

监控平台通过监控主机对摄像机下达操作，远程控制视频，实时监视）

工程图片

Related Products

Current monitoring sensor of arrester in switchgear

Full current measurement range: 0.050 ~ 5.000mA Full current measurement error: ± (standard reading ×1%+5μA) Record the cumulative discharge times :0 ~ 99 times Power supply: DC24V Communication interface: RS-485

Ground resistance sensor

Power supply: dc6 ～ 12V Range: 0.01 Ω- two hundred Ω Accuracy: ± 2%rdg ± 3dgt(20℃ ± 5 ℃, below 70% RH) Communication mode: RS485 Protection grade: IP54

High frequency current sensor

Sensitivity: 5pc Detection frequency band: 50KHz ～ 100MHz Signal output: RS485 Installation position: cable connector ground wire Installation mode: clamp type, clamping

Tilt sensor

Range: ± thirty ° Voltage: 9-35v Output mode: RS485 IP67 protection level

Infrared thermal imaging camera of switch cabinet

Thermal imaging resolution: 160 * 120 Visible light resolution: 200W Power supply: dc12-24 V Temperature range: - 20 ℃ ~ 150 ℃ Accuracy: ± 2 ℃ or 2% of the reading (take the maximum absolute value)

Space UHF PD sensor

Detection frequency band: 300 ~ 1500mhz Protection grade: IP65 Collect the discharge amplitude and phase The service life is more than 8 years

Micro weather sensor

Temperature: measuring range - 40 ~ 60 ℃ ° C Accuracy ± zero point one ° C； two Temperature: measurement range 0 ~ 100% RH Air pressure: measuring range: 10 ~ 1300 Wind speed measurement range: 0-75 M / S

Switch cabinet partial discharge sensor (UHF)

The system adopts UHF principle to conduct local discharge monitoring of high voltage switchgear to ensure the effective monitoring data, and increase system reliability. Ultra low power consumption and 485 bus communication mode are adopted. It is applicable to switch cabinet and ring network cabinet. Each cabinet is equipped with one set to realize the power / qualitative measurement of local discharge. It can be directly connected to the system host without the limitation of host channel.)

Switch cabinet partial discharge sensor (UHF + AE two in one)

The system adopts UHF + AE principle Ultra low power consumption and 485 bus communication mode are adopted, It is suitable for switch cabinet and ring main unit to realize the quantity / qualitative measurement of partial discharge

Intelligent air conditioning / dehumidification linkage device

AC / dc220v power supply is adopted Allowable deviation - 20% ～ + 20% Control output node capacity: AC / dc220v, ≥ 8A Support 2-4 independent node output capability

Intelligent light control unit

Output mode: switch type, realize local and remote control of lighting Wall mounted / 2U rack mounted Using brand devices to ensure reliability Size (mm): 480mm long × 85mm wide × 340mm deep

Intelligent water pump control unit

Output mode: switch type, realize the linkage control of water pump Wall mounted / 2U rack mounted, Using brand devices to ensure reliability Size (mm): 480mm long × 85mm wide × 340mm deep